The UKCA mark is different, in order to display a UKCA mark your door must be tested to the harmonised standard BS EN 13241-1:2003 + A2:2016 and this must be done in the UK by a UK based certified test company, at Rollerdor Ltd all our doors are UKCA marked. As electric garage doors are classed as a machine they are covered by the machinery directive, this means firstly that the top box / roll house must be enclosed to stop entanglement unless it is above 2.5 meters in height, and secondly that as stated by the DHF and Trading Standards. A door operated by a ####x2018;hold to run####x2019; remote control device, capable of being operated without full visibility of the door itself, would be in breach of both the Machinery Directive 2006/42/EC and the Construction Products Regulation (EU) 305/2011, ######xA0;unless######xA0;an additional method (as provided for in the relevant standards) of ensuring the safety of the product can be demonstrated.
This would######xA0;not######xA0;include a video/CCTV facility giving the operator view of the door. Roll Housing / Top box. This is the top box section which the curtain rolls into to cover the working mechanism, for the RD55 it is. The curtain is the main rolling part of a roller door which travels in the guide runners, it is made up of individual slats which are double skin aluminium with a foam filled insulation with the exception of the very last one, which is an extruded aluminium with a rubber insert for sitting on the floor. For the RD55 the dimensions of the slats are.55mm high and 8mm thick. Guide Runners / Legs / Tracks. These are the extruded aluminium runners with double brush inserts that go on each side of the opening for the curtain to run in, for the RD55 the dimensions of these are.
65mm wide by 34mm deep. And they are supplied over sized so you can cut them to your exact measurements as each side can vary when installing the door level and square. Locking Straps / Security Straps. These connect the curtain to the main shaft barrel and supply extra pressure on closing when the limits are set correctly on the door to stop against the curtain being lifted, for the RD55 these are supplied as standard. These are the units that are supplied to control the door that are selected, either a Rocker switch, Key Switch, Hardwired Safety Edge, Wireless Safety Edge or Wireless Safety Edge with ALARM.
The RD55 comes as standard with an internal manual override system, meaning you can open the door by hand from the inside if there is a power failure, if you have no other entrance to your garage other than through the garage door you will need to add an External Override kit to your order. The door in this listing is a Fixed Size product, the opening width.
Guide runners is 2285mm (7ft 6) meaning once you take off the 65mm for the guide runner on each side the maximum drive through width between guide runners is 2150mm (7ft 1####x201D;). The door in this listing is a Fixed Size product, the opening height. Top box is 2135mm (7ft) meaning once you take off the 205mm for the top box, the maximum guide runner height to underside of top box 1930mm (6ft 4####x201D;) but as with all roller garage doors the last slat has to stay in the guide runners when fully open so if you allow an extra 50mm off of the height you would have the rough walk through height available. Top box and Guides: White.
This listing comes as standard with a rocker switch as listed below. Rocker switch: This is a ####x2018;hold to run####x2019; control system that must be installed inside the garage, near the door, so you have a full line of sight of the whole door. Key switch: This is a ####x2018;hold to run####x2019; control system that must be installed inside or outside the garage, near the door, so you have a full line of sight of the whole door.Wireless safety edge: This is for remote control operation working off of a ####x2018;one press####x2019; operation for open and close, with a sensor light on the control box. The standard kit comes with two handsets. Wireless safety edge with ALARM: This is the same as above, but with the addition of an alarm.
DD, EC, TR######xA0;& WC. ####x200B;####x200B;####x200B;####x200B;####x200B;####x200B;####x200B. If your door arrives and does not fit due to incorrect sizes being given and confirmed, then responsibility is held with the customer. If the door arrives and the door does not fit or an error has occurred######xA0;for any reason which is due to Rollerdor Ltd, we######xA0;will endeavor######xA0;to rectify the error within an agreed timescale and at our cost.
Any issues are observed must be reported at your earliest convenience and the item must not be fitted until the issue has been discussed and a solution given with regards to the problem. Rollerdor Ltd will not accept a return of an item that is already been installed.
UKCA Marking: Unlike the CE mark which can be'Frankensteined' together using suppliers CE marks for product, you can usually tell this from suppliers who have terms like CE marked and conforms to the appropriate CE standards or Comply with all current legislation. Machinery Directive: As electric garage doors are classed as a machine they are covered by the machinery directive, this means firstly that the top box / roll house must be enclosed to stop entanglement unless it is above 2.5 meters in height, and secondly that as stated by the DHF and Trading Standards A door operated by a'hold to run' remote control device, capable of being operated without full visibility of the door itself, would be in breach of both the Machinery Directive 2006/42/EC and the Construction Products Regulation (EU) 305/2011, unless an additional method (as provided for in the relevant standards) of ensuring the safety of the product can be demonstrated. This would not include a video/CCTV facility giving the operator view of the door. Roll Housing / Top box: This is the top box section which the curtain rolls into to cover the working mechanism, for the RD55 it is 205mm square Curtain / Slats: The curtain is the main rolling part of a roller door which travels in the guide runners, it is made up of individual slats which are double skin aluminium with a foam filled insulation with the exception of the very last one, which is an extruded aluminium with a rubber insert for sitting on the floor.For the RD55 the dimensions of the slats are 55mm high and 8mm thick. Guide Runners / Legs / Tracks: These are the extruded aluminium runners with double brush inserts that go on each side of the opening for the curtain to run in, for the RD55 the dimensions of these are 65mm wide by 34mm deep and they are supplied over sized so you can cut them to your exact measurements as each side can vary when installing the door level and square. Locking Straps / Security Straps: These connect the curtain to the main shaft barrel and supply extra pressure on closing when the limits are set correctly on the door to stop against the curtain being lifted, for the RD55 these are supplied as standard.
Control Systems: These are the units that are supplied to control the door that are selected, either a Rocker switch, Key Switch, Hardwired Safety Edge, Wireless Safety Edge or Wireless Safety Edge with ALARM. Manual Override: the RD55 comes as standard with an internal manual override system, meaning you can open the door by hand from the inside if there is a power failure, if you have no other entrance to your garage other than through the garage door you will need to add an External Override kit to your order. Item Description Width The door in this listing is a Fixed Size product, the opening width INCLUDING Guide runners is 2285mm (7ft 6") meaning once you take off the 65mm for the guide runner on each side the maximum drive through width between guide runners is 2150mm (7ft 1") Height The door in this listing is a Fixed Size product, the opening height INCLUDING top box is 2135mm (7ft) meaning once you take off the 205mm for the top box, the maximum guide runner height to underside of top box 1930mm (6ft 4) but as with all roller garage doors the last slat has to stay in the guide runners when fully open so if you allow an extra 50mm off of the height you would have the rough walk through height available. Control Systems This listing comes as standard with a rocker switch as listed below: Rocker switch: This is a'hold to run' control system that must be installed inside the garage, near the door, so you have a full line of sight of the whole door. This item is in the category "Home, Furniture & DIY\DIY Materials\Garage Doors & Openers\Garage Doors". The seller is "rollerdor" and is located in this country: GB. This item can be shipped to United Kingdom.